Browne Test Soil (Edinburgh Soil Test)

Description The Browne Test Soil (Edinburgh soil test) is shown to be equivalent to the Edinburgh soil described in ISO/TS 15883-5 standard. It is a simple to use test which can be applied to instruments and internal surfaces of the processing machine, enabling a quick analysis to be made of the washing systems efficacy. Simulates a “worst-case” load. Single application pot. Please note this is a special order due to short shelf life; allow up to a week for delivery. ISO 15883-5 describes performance requirements of test soils used to demonstrate cleaning efficacy of a washer-disinfector. The Browne Washer-Disinfector Test Soil meets the performance requirements for a protein-based test soil specified in B.2 and is shown to be equivalent to the Edinburgh soil provided in Annex A of ISO 15883-5. It is a simple to use test which can be applied to instruments, enabling a quick analysis to be made of the washing system’s efficacy. Browne Test Soil (Edinburgh Soil Test) Features Simulates a worst-case load Readily available Easily stored Easy to prepare Easily reconstituted Easily applied Reproducible results – compared to Edinburgh Soil Contains NO blood products – safe to use   How to use Browne Test Soil (Edinburgh soil test) Add water to fill mark. Stir until the mixture has an even consistency. Leave to stand for 10 minutes Apply the mixture liberally to test load Leave the coated items to dry for between 30 minutes and 2 hours. Record the drying time. Note: Longer drying times will make the soil more difficult to remove. The drying time chosen should reflect typical turnaround times from theatre to decontamination. Process the test load in the washer disinfector. Examine the test items for residual soil. The bright red colour will stand out clearly, highlighting those areas which have not been properly cleaned. Any remaining test soil should be disposed using normal waste disposal after the test has been completed, as reuse may impact product performance.   Possible cause of failure Blocked jets or blocked water inlet filter to washing chamber. Machine load restricting the free flow of water over the instruments or other items. Initial wash temperature too high. Initial wash temperature should be less than or equal to 35°C. Incorrect quantity or type of detergent. Lack of detergent.